Detail zboží
354101 - ČSN EN IEC 60947-4-1 ed. 4 - Spínací a řídicí přístroje nízkého napětí - Část 4-1: Stykače a spouštěče motorů - Elektromechanické stykače a spouštěče motorů | ||
Název : 354101 - ČSN EN IEC 60947-4-1 ed. 4 - Spínací a řídicí přístroje nízkého napětí - Část 4-1: Stykače a spouštěče motorů - Elektromechanické stykače a spouštěče motorů
Označení normy : ČSN EN IEC 60947-4-1 ed. 4 Katalogové číslo : 507606 Třídící znak : 354101 Účinnost : 2019-09-01 Věstník : 2019.08 Strany : 194 Převzata :vyhlášením ve Věstníku - v angličtině TATO NORMA JE NEPLATNÁ | ||
Cena : | 1 191.00 Kč (DPH= 0%), s DPH= 1 191.00 Kč | Nelze zakoupit |
ANOTACE "ČSN EN IEC 60947-4-1 ed. 4 This part of IEC 60947 is applicable to the following equipment: - electromechanical contactors and starters including motor protective switching device (MPSD); - actuators of contactor relays; - contacts dedicated exclusively to the coil circuit of this contactor or this contactor relay; - dedicated accessories (e.g. dedicated wiring, dedicated latch accessory); - intended to be connected to distribution circuits, motors circuits and other load circuits, the rated voltage of which does not exceed 1 000 V AC or 1 500 V DC. This document covers also the assessment procedure for electromechanical overload protection used in safety applications such as protecting a motor located in explosive atmosphere from the outside atmosphere: See Annex L. This document does not apply to: starters for DC motors; NOTE 1: The requirements for DC motor starters are under consideration for the next maintenance cycle. auxiliary contacts of contactors and contacts of contactor relays. These are covered by IEC 60947 5 1; starter used downstream to frequency drive1; NOTE 2: Additional requirements for starter used downstream to frequency drive are under consideration for the next maintenance cycle. short-circuit protective device integrated within starters other than MPSDs. This is covered by IEC 60947 2 and IEC 60947-3; the use of the product with additional measure within explosive atmospheres. These are given in IEC 60079 series; embedded software design rules; cyber security aspects. These are covered by IEC 62443 series. The objective of this document is to state: a) the characteristics of the equipment; b) the conditions applicable to the equipment with reference to: its operation and behaviour, its dielectric properties, its degree of protection, its construction including safety measures against electric shock, fire hazard and mechanical hazard; c) the tests intended for confirming that these conditions have been met, and the methods to be adopted for these tests; d) the information to be given with the equipment or in the manufacturer's literature." |